Swing Tamp Setup; Dual Panel Tamp Setup - ID Technology 252 Operator / Technical Manual

5.15 Swing Tamp Setup

The Swing Tamp Module requires adjustments to provide correct operation and
application of the label to the product. Begin by loosening the four M8 bolts holding the
swing tamp module to the faceplate using a 6mm hex wrench. Slide the tamp module in
the mounting slots until the tamp pad is approximately 1/8" from the peel tip. Be sure the
tamp module is straight up and down then re-tighten the mounting bolts.
With the cylinder all the way home, note the position of the chamfer to the peel edge.
The top surface of the peel plate should, if drawing an imaginary line, intersect the tamp
pad midway up the chamfer (the angled cut across the front edge). If the position is not
correct, extend the tap pad to the apply position, locate the red bumper, and loosen the
locking nut. Adjust the bumper height until the tamp pad chamfer is properly aligned
with the peel edge when the fully retracted to the home position. Tighten the locking nut
to secure the red bumper.

5.16 Dual Panel Tamp Setup

The Dual Panel Tamp Module requires adjustments to provide correct operation and
application of the label to the product. Begin by loosening the four M8 bolts holding the
dual panel tamp module to the faceplate using a 6mm hex wrench. Slide the module in
the mounting slots until the tamp pad is approximately 1/8" from the peel tip. Be sure the
tamp module is straight up and down then re-tighten the mounting bolts.
With the cylinders all the way home, note the position of the chamfer to the peel edge.
The top surface of the peel plate should, if drawing an imaginary line, intersect the tamp
pad midway up the chamfer (the angled cut across the front edge). If the tamp pad height
position is not correct, extend the tamp cylinder to the apply position by hand. Locate
and loosen the lock nut on the air cylinder piston rod. Push the tamp cylinder back into
home position. Adjust the threaded rod in or out until the tamp pad chamfer is properly
aligned with the peel edge when in the fully retracted to the home position. Tighten the
locking nut to secure the air cylinder piston rod.
HALF OF
CHAMFER
PEEL EDGE
1/8"
60
Model 252
Label Printer/Applicator
Operators/Technical Manual