Table of Contents
Advertisement
Storage Environmental Conditions
Temperature..................................0 to 60℃
Humidity.....20% to 90%, non-condensing
3.3 Safety Instructions
Please read the entire instruction manual
before operating the Digital Cel-Gro
Tissue Culture Rotator .
WARNING DO NOT use the Digital
Cel-Gro Tissue Culture Rotator in
a hazardous atmosphere or with
hazardous materials for which the
unit was not designed. Also, the
user should be aware that the
protection provided by the
equipment may be impaired if
accessories used are no provided
or recommended by
the manufacturer, or are used in a
manner not specified by the
manufacturer.
CAUTION ! To avoid electrical
shock, completely cut off power to
the unit by disconnecting the
power cord from the unit
or unplug from the wall outlet.
Disconnect unit from the power
supply prior to maintenance and
service. Any spills should
be removed promptly. Bio hazard
spills should be cleaned using
approved liquid promptly. Solvent
spills are a fire hazard.
7
Section 4 | Overview
Stop the unit immediately, and DO
NOT operate until clean up is
complete and vapors have
dissipated.
DO NOT immerse the unit for
cleaning.
DO NOT operate the unit if it shows
signs of electrical or mechanical
damage.
Note: The rotary plate may have a
little vibration below 11 rpm. The
vibration will relieve or disappear when
more load is added.
Various independent clamps are
available with this Digital Cel-Gro Tissue
Culture Rotator for convenient
combination use. It is applicable for
1.5ml to 50ml microtubes to mix liquid
efficiently and gently. It has an angle
range of 95 to 180 degrees and can
maintain suspension state of biological
samples such as blood mixing.
Applications include blood coagulation
prevention, emulsion diagnosis,
immunoprecipitation, and other related
areas.
Section 5 Operation
This chapter covers the control panel and its operation.
5.1 Control Panel
③
Time
-
+
Run
Run
Stop
⑤
①
②
①. Run/Stop button: Start or stop the
instrument.
②. Run indicator: The light is on when
the instrument is running and off
when the instrument is in standby.
③. Time display window: The window
displays cumulative time (in
continuous mode) or remaining time
(in timer mode).
④. Speed display window: The window
displays set speed (when the
instrument is in standby) or current
speed (when the instrument is
running).
④
Speed
rpm
-
⑥
⑤. Time setting knob: The knob is used
to increase or decrease the set time
of the instrument.
⑥. Speed setting knob: The knob is used
to increase or decrease the set speed
instrument.
⑦
⑧
⑦. Gear I: When the switch is in "gear 1",
the instrument power is on.
⑧. Gear O: When the switch is in "gear
0", the instrument power is off.
Digital Cel-Gro Tissue Culture Rotator
+
8
Advertisement
Table of Contents
