Settings - Thermo Scientific 88882015 Operating Manual

5.4 Settings

Time Settings
1. Continuous mode
Press the Time setting knob. When the
Time display window starts flashing,
turn the knob to increase or decrease
the time to 00:00 and then press the
knob within 5s.
2. Timer mode
Press the Time setting knob. When the
number shown on the Time display
window starts flashing, turn the knob to
increase or decrease the time value.
Press the knob when the time shown on
the Time display window reaches the set
value within 5s.
Speed Settings
Press the Speed setting knob. When the
Speed display window starts flashing,
turn the knob to increase or decrease
the speed value. Press the knob when
the speed shown on the Speed display
window reaches the set value within 5s.
Run and Stop
1. Continuous Mode
Press" "button and the instrument will
Run
Stop
start running with the specified settings
and the RUN indicator light will be on.
The TIME display window will show the
cumulative time and the SPEED display
window will show the current speed.
13 Section 5 | Operation
Press " " button again and the
Run
Stop
instrument will slow down until it stops.
The instrument will then be in standby
and the two display windows will show
the set values.
2. Timer Mode
Press " " button and the instrument
Run
Stop
will start running with the specified
settings and the RUN indicator light will
be on. The TIME display window will
show the remaining time and the SPEED
display window will show the current
speed. Press " " button again and the
Run
Stop
instrument will slow down until it stops.
The instrument will then be in standby
and the two display windows will show
the set values.
Finish Operation
After the operation is finished, press the
power switch at the back right side the
instrument and put it into the "O" state.
Unplug the instrument and store the
instrument according to the storage
guide.
Note: To ensure shaking operation
smooth and steady, it may take 1minute
for the microprocessor control system to
accelerate the tray to the set speed.
Alarm System
Err1: If running speed does not match
the setting speed, the instrument will
have a three-time reboot, and after the
three reboots failed, there will be a
buzzer, and then Err1 will be displayed in
the Time display window .
End of timer: The instrument buzzing
alarm, the "End" is displayed in the Time
display window.
When the instrument alarms, press any
key and the instrument goes into
standby mode.
Power Recovery
If the power supply is cut off suddenly
while the instrument is in operation, the
unit will automatically run at the
previously set parameter upon power
restoration. The display windows will
flash. Press any button to stop the
display window from flashing.
Digital Cel-Gro Tissue Culture Rotator 14