Advertisement
myGuard 7500GL 802.11g Security ADSL Router
Prioritization
There are three priority settings to be provided in the modem:
High
Normal (The default is normal priority for all of traffic without setting).
Low
The trigger of check can base on IP protocol, port number and address.
And the balance of utilization of each priorities are High(60%), Normal(30%) and
Low(10%).
Enable: Select it to activate the function.
Application: A name that identifies an existing rule.
Priority: High or Low, the priority for existing rule. All of traffic will be set to normal priority
until you change it. The balance of utilizations for each priority is High (60%), Normal (30%)
or Low (10%).
Protocol: The name of supported protocol.
Source Port: The source port of packets to be monitored.
Destination Port: The destination port of packets to be monitored.
Source IP Address Range: The source IP address or IP range of packets to be
monitored.
Destination IP address Range: The destination IP address or IP range of packets to be
monitored.
Chapter 4:Configuration
104
Advertisement
