Step 2 Verify Air Flow; Step 3A Ignite The Burner (Option 1) - Eclipse TA Series Installation Manual

Step 2: Verify air flow
TA 015 thru TA 200
Chamber
Pressure
TA 300 thru TA 500
Step 3a: Ignite the burner
(Option 1: Burner not
equipped with bypass
start gas)
1
TA 015, 025, 040, 075, 100, 200
1. Make sure that the pressure tap located on the chamber is
Chamber
2. Connect the manometer to the chamber pressure tap.
Wall
3. Measure the chamber air pressure.
4. Determine actual air flow from the burner specific Data
5. Remove the manometer.
6. Close the pressure tap.
TA 300, 400, 500
1. Make sure that pressure taps A and C are open.
2. Connect the manometer to taps A and C.
3. Measure the air differential pressure.
4. Determine actual air flow from the burner specific Data
Tap
5. Remove the manometer.
6. Close the pressure taps
Tap "A"
Tap "C"
There are two separate ignition procedures which depend upon
whether or not bypass start gas is installed on the burner. Each
procedure is unique and both are outlined below.
Eclipse ThermAir T/A Series v1.10, Installation Guide No. 114, 4/7/06
open.
Sheet (ref.: Air flow vs. Chamber Pressure Chart) for the
burner being setup.
Sheet (ref.: Air flow vs. Air Orifice ∆P Chart) for the burner
being setup.
Note:
A pressure tap is open when the screw inside the tap is
unscrewed approximately half a turn.
Note:
Chamber pressure will directly influence air flow from the
blower. Air flows should be rechecked once the process reaches
its operating temperature and pressure. An oxygen analyzer
may be used to confirm air flow rates once the system is
operating.
Warning:
This procedure assumes that a flame monitoring
control system is installed and is serviceable. It
also assumes that normal low fire start is being
used.
If low fire gas is too low to be used for ignition
consider increasing low fire or providing bypass
start gas. Refer to the section 3b on page 19.
Main Gas
Valve Train