V.ORLANDI E 50 Installation, Operating And Maintenance Instructions page 50

INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS INSTALLATION, OPERATING AND MAINTENANCE INSTRUCTIONS
6)
Check that the coupling jaw is properly
locked in the central position.
If during the various checks, any
component wear has exceeded the
limits shown on page 18/30,
those parts shall be replaced
with new ones immediately.
4.1 PERIODICAL MAINTENANCE
This chapter refers also to the figure on page 21/32.
Depending on the use and at least annually the coupling shall be
N
checked for wear.
O
The following checks and controls are recommended:
T
E
1)
Checking the rubber buffers
Take hold of the coupling and check it, by shaking it forcefully. There
should be no play.
If vertical play exceeds 1 mm the inner bush (7c) must be
replaced. If there is any longitudinal play, the rubber buffers
(8a,8b) must be replaced - see chapter 5.1 REPLACEMENT OF
RUBBER BUFFERS AND INNER BUSH, page 21/32.
DRAWBAR COUPLING E 50
PAG.
18/32
CHAP . 4
REV. F