Installing The Mezzanine Card Bridge Board; System Memory - Dell XC6320 Owner's Manual

Figure 29. Removing and installing the mezzanine card bridge board
1. PCI slot
Related Links
Removing the system board assembly
Removing the LSI 2008 SAS mezzanine card

Installing the mezzanine card bridge board

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
Follow the safety guidelines listed in the Safety instructions section.
Install the mezzanine card bridge board into the mezzanine slot on the system board.
1. Install the mezzanine card.
2. Install the system board assembly.
3. Reconnect the peripherals and connect the system to the electrical outlet.
4. Turn on the system, including any attached peripherals.
Related Links
Installing the LSI 2008 SAS mezzanine card
Installing a system board

System memory

System memory holds the instructions that the processor executes. Each system board has sixteen DDR4
memory module sockets for the installation of up to sixteen registered DDR4-2400 MHz (2400 MHz at 2
memory modules per channel) memory modules to support processor 1 and processor 2. For the
location of the memory modules, see the C6320 system board connectors section.
2. mezzanine card bridge
65