Serial Communication Details; System Profile Settings Details - Dell XC6320 Owner's Manual

Serial Communication details

The Serial Communication screen details are explained as follows:
Serial
Selects serial communication devices (Serial Device 1 and Serial Device 2) in BIOS.
Communication
BIOS console redirection can also be enabled and the port address can be
specified. This option is set to Auto by default.
Serial Port Enables you to set the port address for serial devices. This option is set to Serial
Address Device 1=COM2, Serial Device 2=COM1 by default.
External Serial Enables you to associate the External Serial Connector to Serial Device 1, Serial
Connector Device 2, or the Remote Access Device by using this option.
Failsafe Baud Rate Specifies the failsafe baud rate for console redirection. The BIOS attempts to
determine the baud rate automatically. This failsafe baud rate is used only if the
attempt fails, and the value must not be changed. This option is set to 115200 by
default.
Remote Terminal Sets the remote console terminal type. This option is set to VT 100/VT 220 by
Type
default.
Redirection After Enables or disables the BIOS console redirection when the operating system is
Boot loaded. This option is set to Enabled by default.

System Profile Settings details

The System Profile Settings screen details are explained as follows:
System Profile Sets the system profile. If you set the System Profile option to a mode other than
Custom, the BIOS automatically sets the rest of the options. You can only change
the rest of the options if the mode is set to Custom. This option is set to
Performance Per Watt Optimized (DAPC) by default. DAPC is Dell Active Power
Controller.
NOTE: You can use only Serial Device 2 for the Serial Over LAN (SOL) feature.
To use console redirection by SOL, configure the same port address for
console redirection and the serial device.
NOTE: Every time the system boots, the BIOS syncs the serial MUX setting
saved in iDRAC. The serial MUX setting can independently be changed in
iDRAC. Loading the BIOS default settings from within the BIOS setup utility
may not always revert the serial MUX setting to the default setting of Serial
Device 1.
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use
console redirection by SOL, configure the same port address for console
redirection and the serial device.
NOTE: Every time the system boots, the BIOS syncs the serial MUX setting
saved in iDRAC. The serial MUX setting can independently be changed in
iDRAC. Loading the BIOS default settings from within the BIOS setup utility
may not always revert this setting to the default setting of Serial Device 1.
NOTE: All the parameters on the system profile setting screen are available
only when the System Profile option is set to Custom.
29