Removing The Satadom - Dell XC6320 Owner's Manual

NOTE: Write intensive activities and processes leveraged by XC appliances, are intended to take
place on the SSDs and HDDs and not the boot device.
The hypervisor boot device is not intended for application use.
WARNING: Adding additional write intensive software to the SATADOM boot disk results in heavy
wear on the device beyond design specifications resulting in premature hardware failure.
You should not run applications on the hypervisor operating system.
Examples of write intensive applications
Following are the examples of write intensive applications:
• System Center Agents.
– System Center Configuration Manager (CCMExec.exe).
– System Center Operations Manager (MonitoringHost.exe).
• Write‐intensive Agents.
• Databases.
• Disk management utilities (third-party disk defragmentation or partitioning tools).
• Additional roles outside of the appliance's intended use (web server, domain controller, RDS, and so
on.).
• Client‐based Antivirus.
• Run Virtual Machines directly on the SATADOM. Ensure that the Virtual Machines run on Solid State
Drives (SSDs) and Hard Disk Drives (HDDs).

Removing the SATADOM

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Turn off the system, including any attached peripherals.
3. Disconnect the system from the electrical outlet and disconnect the peripherals.
1. Disconnect the power cable from the SATADOM and the system board.
2. Using a screwdriver, press the metal latch to release the SATADOM.
3. Holding the SATADOM by its edges, pull the SATADOM until the card edge connector disengages
from the onboard SATA connector 5 on the system board.
46