Cable Routing For Satadom And Lsi 2008; Power Supply Units - Dell XC6320 Owner's Manual

Cable routing for SATADOM and LSI 2008

Figure 16. Cable Routing for SATADOM and LSI 2008
Table 8. Cable Routing for SATADOM and LSI 2008
Item Cable
1 LSI 2008 SAS
Mezzanine card
2 Mini-SAS cable
SATADOM
3
power cable
4 Mini-SAS
connector 0-3
(J3)
5 System board

Power supply units

NOTE: Configurations higher than indicated in the table may change the PSU mode to non-
redundant. In non-redundant mode if the power requirement exceeds the installed system power
capacity, the BIOS will throttle the processors. Also, since Processor Power Capping is enabled,
processor throttling occurs on configurations that exceed the cap value.
NOTE: Both the PSUs are hot swappable, and they can support hot swap in any condition if the
system has power throttling feature.
The following table lists the maximum supported configuration where power supply unit (PSU)
redundancy is guaranteed:
48
From (LSI 2008 SAS Mezzanine
Card)
Mini-SAS connector 4-7 (J4)
On LSI 2008 SAS Mezzanine Card
SATADOM
On LSI 2008 SAS Mezzanine Card
To (System Board)
SAS/SATA connectors 4 and 5
HDD Power Connector on the
system board
Mini-SAS HD Connector 0-3