Table of Contents
Advertisement
Installing the Mezzanine card
Prerequisites
1. Follow the safety guidelines listed in the
Safety instructions
section.
2. Follow the procedure listed in the
Before working inside your sled
section.
Steps
1. Align the connector on the Mezzanine card with the connector on the system board.
2. Place the Mezzanine card on the connector, and press the blue push point until firmly seated.
3. Using the Phillips #2 screwdriver, tighten the captive screw on the Mezzanine card.
Figure 84. Installing the Mezzanine card on the system board
90
Installing and removing sled components
Advertisement
Table of Contents
