Table of Contents
Advertisement
PolyGard
Multi-Point Controller
®
LGC-LG2 – UserManual
LGC-LG2 – UserManual
User Manual - LGC/LG2-04
LGC-LG2 – UserManual
2.3
Password Level
All changes of parameters and staged setpoint values are protected by four digit numeric Code (= password).
The code level 1 permits the operation of the LGC/LG2-04. This code level is intended for the customer. This code
can be individually changed in System Setup Menu with valid Code 2 Password.
With the code level 2 all parameters and set points can be changed, this code level is reserved for the service
technician.
A third code level permits activation or deactivation of sensor points (SP).
A password must be re-entered if 15 minutes goes by without the press of a push button.
All menu windows can be seen without a password required.
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols
12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | USA 160104 | Page 6 of 30
Specifications subject to change without notice. | USA 131119 | Page 6 of 30
Specifications subject to change without notice. | USA 200211 | Page 6 of 30
PolyGard
Fax (858) 578-4633 & (888) FX INTEC
www.inteccontrols.com
Page 06
is a registered trademark of MSR-Electronic GmbH | LGC/LG2-04
Polygard® is a registered trademark of MSR | LGC/LG2-04
®
Specification subject to change without notice.
LGC/LG2-04
Printed in USA 131119
Advertisement
Table of Contents
