Manual Operation Of The Relay; Menu Sensor Values - Intec PolyGard LGC/LG2-04 User Manual

PolyGard Multi-Point Controller
®
LGC-LG2 – UserManual LGC-LG2 – UserManual
User Manual - LGC/LG2-04
LGC-LG2 – UserManual
3.3.1

Manual operation of the relay

The manual operation of the relays occurs in the menu „Relay Status". If a relay is in the manual ON or OFF
status, the yellow LED at the Controller is on continuously.
The external operation of the alarm relay over an assigned digital input has the priority before the manual
operation in the menu "Relay Status" and exceeding the Stage set point assigned.
In the menu „Relay Status" any manually operated relays can be reset by selecting the "Automatic" mode.
Acknowledgment of the relays in Latching mode also is a function in this menu.
R 01
OFF
Manual ON
Manual OFF
Manual OFF
3.4

Menu Sensor Values

In this menu you can display the current value (CV) and average value (AV) with sensor unit and type for each
active sensor point (SP) as well as the define the mode of control (CV or AV mode).
SP 01 NH3 ppm
50 *CV 33 AV
Symbol Description
Sensor
SP 01
Point No.
NH3 Ttype
ppm Unit
CV Current value
AV Average value
* Control mode
Not active SP Status
Error SP Malfunction
Polygard® is a registered trademark of MSR
Customer Services (858) 578-7887 & (888) GO INTEC
INTEC Controls, 12700 Stowe Dr., Suite 100, Poway, CA 92064 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | relevantsolutions.com/inteccontrols
INTEC Controls | 12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.INTEC | inteccontrols.com
Specifications subject to change without notice. | USA 131119 | Page 10 of 30 Specifications subject to change without notice. | USA 160104 | Page 10 of 30
Specifications subject to change without notice. | USA 200211 | Page 10 of 30
Select Relay
Select Function Manual operation
Manual ON
Select Function Manual OFF
Automatic
Reset ?
Relay forced to OFF Condition
Setting
Function
Status
Select SP No
NH3 See 3.6.2
See 3.6.2
CV Current value of Gas Concentration
Average value (10 measured values within the time unit)
Display, with Control mode is select. (CV or AV)
Not active SP not announced
Current signal < 3 mA or > 22 mA
PolyGard
Fax (858) 578-4633 & (888) FX INTEC
www.inteccontrols.com
Page 10
= Relay ON
= Relay OFF
= Automatic operation restored
= Acknowledging Latching mode
is a registered trademark of MSR-Electronic GmbH | LGC/LG2-04 Polygard® is a registered trademark of MSR | LGC/LG2-04
®
Specification subject to change without notice.
LGC/LG2-04
Printed in USA 131119