Miele PWT 6089 Vario Operating And Installation Instructions page 61

Message in the display
p
Water intake fault
Open the stopcock
and
check the inlet hose.
,
Technical fault
If restart is
unsuccessful,
contact Technical
Service.
,
Fault
Disinfection
temperature
not reached
q
Drain fault
Clean the drainage
system
Fill the container
or
O
Fault
Container empty
A To switch off the fault message, press the jog shuttle.
Possible cause
The water inlet is
blocked or restricted.
The water pressure is
too low.
There is a fault.
During the disinfection
program the water
temperature was not
reached.
The water outlet is
blocked or restricted.
One of the external
detergent containers is
empty.
Problem solving guide
Remedy A
Check whether
– the stopcock is opened
properly.
– the inlet hose is kinked.
– Select Low water
pressure in the
Settings/Supervisor level
menu.
Start the program again.
If the fault message appears
again, contact the Miele Ser-
vice.
The washer-extractor has
not carried out the
disinfection cycle correctly.
Start the program again.
Drain pump version: Clean
the drainage system.
Drain valve version: Call the
Service Department.
See "Detergent - Empty
sensor".
61