Miele PWT 6089 Vario Operating And Installation Instructions page 62

Problem solving guide
Problem
1
Adjust the load
The drum is empty or
the laundry is too dry.
;
Technical fault
If restart is unsuccessful,
call Service.
A fault number (e.g.
F43) might also be
displayed.
:
Power failure
Program stopped
Press OK button
E
Clean out airways
Clean the lint filter.
Check ducting
appears after a while.*
* You can adjust the setting which controls if or when the check message
appears:
See "Clean the filter" and "Cleaning out airways" in the "Settings/Supervisor level
menu" in the separate booklet "Tumble dryer Commissioning, Program chart and
Settings" supplied.
62
Possible cause
This is not a fault.
In some programs, if the
drum has been
overloaded or
underloaded, the
program will be
canceled. This can also
happen if the items are
already dry.
A program cannot be
started while there is a
fault message in the
display.
If the dryer is switched
off during a drying
program or there has
been a power cut:
Reminder to clean the
filter.
Remedy
Use the Hot air program
(timed drying) to dry
individual items.
To delete the message:
– Open the door.
– Make a note of what
is shown in the
display.
– Try to start the
program again.
– When the dryer is
switched on again
and/or the power is
restored, confirm with
OK and start the
program again.
– Clean the lint filter.
To delete the message:
– Confirm with OK.