Table of Contents
Advertisement
3.
Select H.264 or H.265.
12.1.4 Configure Capture
You can configure the picture resolution of the front and rear cameras.
Steps:
1.
Tap Config. > Taking Picture.
2.
Tap Rear Camera or Front Camera to set the picture resolution. 2M, 5M, 8M, and 13M are selectable for the rear camera.
2M, 5M, and 8M are selectable for the front camera.
12.1.5 Configure OSD
You can display time, positioning information, and camera name on the video.
Steps:
1.
Tap Config. > OSD.
2.
Tap Rear Camera or Front Camera.
3.
Tap OSD Content to select the content to display.
4.
Set the display position. Drag the slider to adjust the Time Display Position, GPS Info. Display Position, and Camera
Name Display Position.
5.
Tap Camera Name Content to set the camera name.
Configure Storage Location
The device provides a built-in 32 GB storage space, and supports up to 128 GB external MicroSD card for storage. Prior storage
space can be set, and the files will be saved on the other storage space until the prior storage space is full. When both the
storage spaces are full, a message will be displayed to send a notification.
Steps:
1.
Tap Config. > Other Advanced Config. > Storage Location.
2.
Tap Video & Audio Storage Location, and select the storage priority for the audio & video stream.
Internal SD Card First: Give the storage priority to the internal storage space.
External SD Card First: Give the storage priority to the external storage space.
Configure Pre-Record
You can set the time before recording. For example, if you set the pre-record time as 5 seconds, and you manually started the
recording at 10:00, then the camera recorded it at 9:59:55.
Steps:
1.
Tap Config. > Other Advanced Config. > Pre-Record.
2.
Check Pre-Record to enable the function.
3.
Tap Pre-Record Time to select the time.
4.
Reboot the device to activate the settings.
User Manual of Portable Video Recorder
36
Advertisement
Table of Contents
