Select The Roofing Filter; Turn The Spectrum Display Off - Yaesu FTDX10 Operation Manual

Filter Function Display
Displays the passband status of the DSP filter. The operation of WIDTH, SHIFT, NOTCH, CONTOUR etc.
can be observed.
The current roofing filter bandwidth is displayed as a blue line below the filter function display.
SSB Mode
Roofing filter bandwidth
Touch the filter display to reveal and check the setting value of the last used function from SHIFT, WIDTH, NOTCH,
CONTOUR, and APF. The setting may be changed by turning the knob of the active function.
Example: When the last function used is the NOTCH function
Touch the filter display to display the NOTCH function setting value.

• Select the roofing filter

Touch [R.FIL] in to display the roofing filter selection screen on the display. Touch the bandwidth of the
desired filter to select it.

• Turn the spectrum display OFF

To display only the DSP filter bandwidth information, press and hold the spectrum area of the filter func-
tion display to clear the spectrum view. To display it, press and hold again.
20
Passband status of DSP filter
(SHIFT, WIDTH)
State of NOTCH
CW Mode
DSP filter bandwidth
State of CONTOUR
RTTY Mode
Selectable filters (bandwidth)
PSK/DATA Mode