Yaesu FTDX10 Operation Manual page 105

OPERATION SETTING
- TX GENERAL -
HF MAX POWER
Function: Sets the transmit RF power output of
the HF band.
Available Values: 5 - 100W
Default Setting: 100W
50M MAX POWER
Function: Sets the transmit RF power output of
the 50 MHz band.
Available Values: 5 - 100W
Default Setting: 100W
70M MAX POWER
Function: Sets the transmit RF power output of
the 70 MHz band.
Available Values: 5 - 50W
Default Setting: 50W
AM MAX POWER
Function: Sets the transmit RF power output of
the AM mode.
Available Values: 5 - 25W
Default Setting: 25W
VOX SELECT
Function: Selects the function of
tion.
Available Values: MIC / DATA
Default Setting: MIC
Description:
MIC: Operates via input from the MIC jack (mi-
crophone).
DATA: Operates via input from the RTTY/DATA or
USB jack.
DATA VOX GAIN
Function: Sets the VOX GAIN while operating
VOX during the sending/receiving of
data (PSK, RTTY, etc.).
Available Values: 0 - 100
Default Setting: 50
Description: Set the data input VOX gain to the
point that the data signal reliably
engages the transmitter, and also re-
leases the transmit when there is no
data signal.
104
EMERGENCY FREQ TX
Function: Enables TX/RX operation on the Alas-
Available Values: OFF / ON
Default Setting: OFF
Description: When this Menu Item is set to "ON",
Important: The use of this frequency is restrict-
the VOX opera-
ka Emergency Channel, 5167.5kHz.
the spot frequency of 5167.5 kHz will
be enabled. The Alaska Emergency
Channel will be found between the
PMS memory channel "M-P9U (or
5-10)" and the memory channel "M-
01".
ed to stations operating in or near
Alaska, and only for emergency pur-
poses (never for routine operations).
See §97.401(c) of the FCC regula-
tions.