Performing A Hotsync ® Operation Using The Bluetooth™ Function; Only); Performing A Hotsync ® Operation Using The Bluetooth™ Function (For Bluetooth™ Built-In Models Only) - Sony PEG-NZ90 CLIE Handbook (primary manual) Handbook

Performing a HotSync
Bluetooth™ function
If you are using a Bluetooth compatible computer, you can perform a wireless
®
HotSync operation between your CLIÉ handheld and computer.
Prior to performing a HotSync
Bluetooth™ function
To perform a HotSync
using the Bluetooth™ function, you need to configure a new connection setting
for Bluetooth™ to register your computer as an available connection device.
Preparing your CLIÉ handheld
Note
Prior to performing the following procedure, enable the Bluetooth™ function of your
computer. For details, refer to the manual of your computer.
1
Tap the arrow V in the top right-hand corner of the
Preferences screen and select Connection.
2
Tap New....
3
Enter Name.
Enter a unique name for each computer.
"Custom" is displayed by default.
4
Tap the arrow V next to Connect to and select PC.
5
Tap the arrow V next to Via and select Bluetooth.
6
Tap Tap to discover next to Device.
Your CLIÉ handheld starts to detect Bluetooth compatible devices located
within a range of the communication area.
When detection is complete, Bluetooth compatible devices around your
CLIÉ handheld are listed.
Exchanging and updating data using a HotSync
®
(Other HotSync operations)
®
operation using the
(for Bluetooth™ built-in models only)
®
®
operation between your CLIÉ handheld and computer
®
operation
operation using the
Continued on next page
106