Sony PEG-NZ90 CLIE Handbook (primary manual) Handbook page 108

Performing a HotSync
(for Bluetooth™ built-in models only)
Tips
• Depending on Bluetooth compatible devices, the procedure to display the Passkey
Input dialog box may be different from the above instructions or the Passkey input
dialog box may not be displayed. In this case, follow the on-screen instructions and
enter a passkey as needed.
• Depending on the radio wave conditions, it may take time to complete detection or
establish a communication.
• If it takes too much time to detect the Bluetooth compatible computer, tap Cancel and
try again.
• If the Bluetooth compatible computer cannot be detected, try again.
Performing a HotSync
function
1
Enable the Bluetooth™ function on your computer.
2
Check that the HotSync
Windows task tray (bottom right-hand corner of the taskbar)
on your computer.
Tip
If the HotSync
menu, click Programs (All Programs in Windows XP), Sony CLIE, and
HotSync Manager to start the HotSync manager.
3
Rotate the Jog Dial™ navigator to select the HotSync icon
and press the Jog Dial™ navigator on the Application
Launcher screen.
The HotSync screen is displayed.
Tip
You can also tap the HotSync icon to display the HotSync screen.
4
Check that Local is selected.
Exchanging and updating data using a HotSync
®
(Other HotSync operations)
®
operation using the Bluetooth™ function
®
operation using the Bluetooth™
icon is not displayed in the Windows task tray, from the Start
®
icon is displayed in the
Continued on next page
operation
108