Table of Contents
Advertisement
Connecting power through the device power ports
The DC 12V connector (1,
port. The unit is exclusively designed to accept passive 12 Vdc power
from an AC power adapter producing a minimum of 60W (12V/5A).
Figure 9. FM1000 Gateway (DC 12V connector)
CAUTION
Do not connect a 24 Vdc or 48 Vdc power source to the unit
under any circumstances.
4.1.5. Rebooting the firmware and resetting the unit to factory
defaults
The Cisco FM1000 Gateway hardware can be rebooted and reset to
factory default condition using the procedures in this section.
IMPORTANT
The following procedure shows how to do a 'hard' (device
firmware) reboot. To do a 'soft' (device software) reboot, refer
to
To do a 'hard' (device firmware) reboot under emergency conditions (for
example, if the unit malfunctions), do the steps in the following sub-
section.
Device firmware reboot
1.
Connect one end of an RS-232 serial cable to either of the COM
ports on the rear side of the unit (1 or 2,
© 2021 Cisco and/or its affiliates. All rights reserved.
Figure 9 (page
"Resetting the unit to factory defaults" (page
Hardware installation
29)) is a two-terminal power
105).
Figure 10 (page
30)).
Page 29 of 138
Advertisement
Table of Contents
