Table of Contents
Advertisement
Fluidmesh gateways
Figure 3. Hierarchical network architecture with relative IP
addressing
NOTE
The system architecture shown above is to be regarded as
indicative only.
The FM1000 Gateway is necessary for the cluster to function if
the cluster aggregate throughput is greater than 350 Mbps, but
less than 1 Gbps. If throughput is less than 350 Mbps, a
Fluidmesh radio transceiver may be used to facilitate an L2TP
tunnel to the global gateway.
The FM10000 Gateway is only necessary as a global gateway
if the overall aggregate throughput value is between 1 Gbps
and 10 Gbps. If throughput is less than 1 Gbps, an FM1000
Gateway can replace an FM10000 Gateway as a global
gateway unit.
Figure 3 (page 18)
relative IP addressing.
Within this schema:
• An FM1000 Gateway Gateway is used as an aggregate point within
each single network cluster or broadcast domain.
© 2021 Cisco and/or its affiliates. All rights reserved.
shows a typical hierarchical network architecture with
Getting Started
Page 18 of 138
Advertisement
Table of Contents
