Yamaha Audioversity Rivage Pm Series Network Setup Manual page 7

2. On the FOR MIXER CONTROL tab, press the IP ADDRESS button to open the DSP
ENGINE IP SETTING screen. Then, specify an IP address and subnet mask.
The following IP addresses cannot be used for DSP ENGINE IP SETTINGs.
192.168.53.xxx /24
•
172.17.xxx.xxx /16 - 172.24.xxx.xxx/16
(These are reserved for RIVAGE PM systems.)
169.254.xxx.xxx /16 (Link-local addresses)
•
• Multicast addresses
IP address assigned to CONSOLE IP SETTINGs
•
IP addresses in the same subnet as the HY144-D/-SRC's assigned Dante network
•
3. Press the ENABLE button in the DSP ENGINE IP SETTING field to turn it on.
NOTICE
• Always apply the IP address to CONSOLE IP SETTING and DSP ENGINE IP SETTING
before turning the ENABLE button ON for use with the StageMix or MonitorMix apps.
Also, when you are not using the function, turn the ENABLE button off.
7