Altronix Trove T1SAK3F4 Installation Manual page 5

1. Fasten standoffs onto metal pems configuration (A) of backplane (Fig. 4, pg. 5).
2. Position Salto modules over corresponding standoffs and mount them utilizing pan head screws (provided) (Fig. 4a, pg. 5).
3. Mount backplane to enclosure with hardware.
Salto Access Controller
CU42E0, CU4200 or CU4EB8
Fig. 4
Altronix
eFlow104NB
AC1
L G N
Altronix
eFlow102NB
AC1
L G N NC C NO NC
AC FAIL
IN GND IN GND IN GND IN GND IN GND IN GND IN GND IN GND
1 2 3 4 5 6 7
F1 F2 F3 F4 F5
Altronix ACM8
NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM NC C NO COM
OUTPUT 1 OUTPUT 2 OUTPUT 3 OUTPUT 4 OUTPUT 5
Altronix
ACM4
-- + -- +
POWER CONTROL
+INP- T +RET-
NO C NC
INTERFACE
FACP
Trove / SALTO Kits
T2SAK75F12: Configuration of Salto Modules:
Access Controller Position Chart for the Following Models:
AC DC
1 min enable
NC C NO NC C NO TRIGGER EOL NO GND
2 hr disable + AUX -
AC FAIL BAT FAIL SUPERVISED RESET
AC DC
1 min enable
C NO TRIGGER EOL NO GND
2 hr disable + AUX -
SUPERVISED
BAT FAIL RESET
FACP
TRIGGER
TRG
INPUT
8
F6 F7 F8
O N O N O N O N
1 1 2 2 3 3 4 4 1 1 2 2 3 3 4 4
MAIN
10A 250V
OUTPUT 6 OUTPUT 7 OUTPUT 8
Altronix PDS8
IN2 Fuse
+ INP1 - + INP2 -
A A
A A
A A
Pem Mounting
A
Fig. 4a
Backplane
Pem
Standoff
HS4 Module
Pan Head
Screw
- 5 -