Safety Information; Introduction; General Safety - Thermo Scientific SlideMate AS Operator's Manual

Safety Information

Introduction

Pyramid Innovation Ltd products are designed for convenient and reliable service; however, incorrect
actions by a user may damage the equipment, or cause a hazard to health.
The following sections contain important information for the safe setup and use of the instrument.
The following sections contain important information for the safe setup and use of the
instrument, and should be read and understood by the user before using the instrument.

General Safety

This instrument, as supplied, conforms to IEC 61010-1; however, the addition of
chemicals introduces potential hazards. Good Laboratory Practice must be employed and
consideration must be given to the potential for hazard when dealing with these chemicals.
Do not remove any panels or access covers, unless specifically instructed to do so.
The instrument does not have any user serviceable parts. Potentially lethal
voltages are present inside the instrument.
The instrument must be positioned such that it is possible to interrupt the Mains
supply at the source by removing the plug from the socket.
Use only factory approved accessories or replacement parts within the instrument.
Position the instrument such that it is possible to interrupt the Mains supply at
the source by removing the plug from the socket.
If the equipment is used in a manner not specified by Thermo Fisher Scientific,
the protection offered by the equipment may be impaired.

All users must have read and understood the Operator Guide and these safety instructions;
and only operate the unit in accordance with the instructions.

Any problems and queries should be referred to your Pyramid Innovation supplier.

Correct maintenance procedures are essential for consistent performance. It is
recommended that a Maintenance Contract is taken out with our Service Department.

Any maintenance or service work required may only be carried out by trained personnel.

The instrument should be placed on a suitable level surface and not in direct sunlight.

Only use cleaning agents recommended in the Operator Guide
A83910100 Issue 1
7