Table of Contents
Advertisement
Project-specific information takes precedence over any other general information found
in this manual. Such information may include:
Schematic Drawings: describe internal power and signal wiring
•
Shop Drawings: describe mounting methods to structural elements, access method
•
(front or rear), and power and signal entrance points
System Riser Diagrams: describe power and signal connections between system
•
components and the control location; may also include control room layout and
schematic
Final Assembly Drawings: describe internal component locations and detailed
•
product appearance with part numbers and quantities
Ensure all applicable material has been gathered before beginning the installation.
Contact a Daktronics sales coordinator or project manager.
Daktronics Nomenclature
Most components have a white label that lists the part number
(Figure 2). Part numbers will also appear on certain drawings. If a
component is not found in the Replacement Parts (p�11), use
the label to order a replacement. Refer to Section 6: Daktronics
Exchange and Repair & Return Programs (p�12) if replacing or
repairing any component.
Main Component Labels
Part Type
Individual circuit board
Assembly; a collection of
circuit boards
Wire or cable
Fuse
Transformer
Metal part
Fabricated metal assembly
Specially ordered part
Accessory Labels
Part Number
Component
0P-XXXX-XXXX
Termination block for
power or signal cable
0A-XXXX-XXXX
Grounding point
W-XXXX
Power or signal jack
Power or signal plug for
F-XXXX
the opposite jack
T-XXXX
0M-XXXXXXX
0S-XXXXXX
PR-XXXXX-X
Introduction
2
0P-1127-0024
SN:
2465
02/19/12 Rev. 1
Figure 2: Part Label
Label
TBXX
EXX
JXX
PXX
Advertisement
Table of Contents
