Daktronics Nomenclature - Daktronics Sportsound SSN-150 Installation Manual

This manual is not specific to a particular installation. Project-specific information takes
precedence over any other general information found in this manual. Such information
may include:
Schematic Drawings: describe internal power and signal wiring
•
Shop Drawings: describe mounting methods to structural elements, access method
•
(front or rear), and power and signal entrance points
System Riser Diagrams: describe power and signal connections between system
•
components and the control location; may also include control room layout and
schematic
Final Assembly Drawings: describe internal component locations and detailed
•
product appearance with part numbers and quantities
Ensure all applicable material has been gathered before beginning the installation.
Contact a Daktronics sales coordinator or project manager.

Daktronics Nomenclature

Most components have a white label that lists the part number
in bold as shown in Figure 2. Part numbers may also appear
on illustrations and reference drawings as well as in the Bill of
Materials (BOM) for the project. If a component is not found in the
Replacement Parts (p�27), use the label to order a replacement.
Refer to Section 7: Daktronics Exchange and Repair & Return Programs (p�31) if
replacing or repairing any component.
Main Component Labels
Part Type
Individual circuit board
Assembly; a collection of
circuit boards
Wire or cable
Fuse
Transformer
Metal part
Fabricated metal assembly
Specially ordered part
Accessory Labels
Part Number Component
0P-XXXX-XXXX
Termination block for
power or signal cable
0A-XXXX-XXXX
Grounding point
Power or signal jack
W-XXXX
Power or signal plug for
F-XXXX
the opposite jack
T-XXXX
0M-XXXXXXX
0S-XXXXXX
PR-XXXXX-X
Introduction
2
0P-1127-0024
SN: 2465
02/19/12 Rev. 1
Figure 2: Part Label
Label
TBXX
EXX
JXX
PXX