Rehau NEA SMART 2.0 End User Manual page 25

Establishing a wireless connection to the Internet
In order to connect the base to the Internet, it is neces-
sary to enter the access data of the wireless LAN
network (the router). To do this, follow the steps in
chapter 5 to get to the input field for the access data.
Then perform the following steps:
1
On the integrated web pages, go to the IT Settings
menu item.
2
Enter the SSID and the password (WPA key) of the
wireless LAN network and confirm the entry.
3
< OK >
> 3 sec
Press both arrow buttons at the same time for
> 3 seconds
RZ11 RZ12 COOL ZBUS1
DI3 DI4 WIFI/LAN AP
The WIFI/LAN LED and/or the AP LED will begin to
flash.
End user manual
WIFI and LAN o
WIFI/LAN AP
Cloud Mode
WIFI/LAN AP
Access Point Mode
WIFI/LAN AP
Confirm by briefly pressing the OK button. The current
status of the transmitting function is displayed.
4
WIFI/LAN AP
By briefly pressing the right arrow button, it is possible
to switch between the transmitting functions (none,
direct connection, server connection). Press the right
button repeatedly until the direct connection is acti-
vated. In this case, the WIFI/LAN LED flashes and
the AP LED lights up permanently.
5
< OK >
< 1 sec
Confirm by briefly pressing the OK button.
6
WIFI/LAN AP
The WIFI/LAN LED will start to light up permanently
after no more than 2 minutes. The base station is
now connected to the Internet and the REHAU server.
25