Rehau NEA SMART 2.0 End User Manual page 17

2
WIFI/LAN AP
By briefly pressing the right arrow button, it is possible
to switch between the transmitting functions (none,
direct connection, server connection). Press the right
button repeatedly until the direct connection is acti-
vated. In this case, the WIFI/LAN LED flashes and the
AP LED lights up permanently.
3
< OK >
< 1 sec
Confirm by briefly pressing the OK button.
If no buttons are pressed for a certain time, the NEA
SMART 2.0 Base will return to the initial state.
In this case, the sequence for activating the transmit-
ting function can be started again with step 2.
The NEA SMART 2.0 Base is now ready for direct
connection to a PC or a tablet/smartphone.
With the transmitting function activated, the wireless
LAN network transmitted by the NEA SMART 2.0 Base
is visible to every user – similar to the wireless LAN
network of a router. It is recommended to change the
default password during the initial set-up.
If the password has been forgotten, it can be reset to
the delivery status.
End user manual
Establishing a connection between the Base and the
PC/tablet/smartphone
Before performing the following steps, the transmit-
ting function on the NEA SMART 2.0 Base must be
switched on.
1
On the PC/tablet/smartphone, open
the wireless LAN menu and view the
available networks. NOTE: The distance
between the PC/tablet/smartphone should
not exceed approx. 5 m.
2
Select the wireless LAN network with
the name "REHAU-xxxxxx".
17