Rehau NEA SMART 2.0 End User Manual page 24

24 End user manual
Activating communication
When the system is delivered, the communication
functions of the NEA SMART 2.0 Base via wireless
LAN and LAN are switched off.
1
Insert the LAN cable into the NEA SMART 2.0 Base as
well as into the router/network socket.
2
< OK >
> 3 sec
Press both arrow buttons at the same time for
> 3 seconds
RZ11 RZ12 COOL
DI3 DI4 WIFI/LAN
The WIFI/LAN LED and/or the AP LED will begin to
flash.
WIFI/LAN AP
WIFI/LAN AP
WIFI/LAN AP
Confirm by briefly pressing the OK button. The current
status of the transmitting function is displayed.
ZBUS1
AP
WIFI and LAN o
Cloud Mode
Access Point Mode
3
WIFI/LAN AP
By briefly pressing the right arrow button, it is possible
to switch between the transmitting functions (none,
direct connection, server connection). Press the right
button repeatedly until the direct connection is acti-
vated. In this case, the WIFI/LAN LED flashes and the
AP LED lights up permanently.
4
< OK >
< 1 sec
Confirm by briefly pressing the OK button.
5
WIFI/LAN AP
The WIFI/LAN LED will start to light up permanently
after no more than 2 minutes. The base station is
now connected to the Internet and the REHAU server.
If no buttons are pressed for a period of time, the base
will return to the initial state. In this case, the sequence
for activating the transmitting function can be started
again from step 2.
The app can now be connected as described above.