Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Genexis Pulse Series
Summary of Contents for Genexis Pulse Series
- Page 1 EX400 Pulse–Series Installation Guide...
- Page 2 LED & button overview Status – power on Green Green (blinking) – booting – power off Broadband Green – uplink and IP connectivity Yellow – uplink and connectivity to router – uplink and IP connectivity lost – no uplink 2.4G Green –...
- Page 3 Port overview LAN port Power port Reset ON/OFF port button switch port Reset button (recessed) ON/OFF switch Reset – press and hold 10 seconds Switch ON – flip the switch to ON Switch OFF – flip the switch to OFF...
- Page 4 Pulse EX400 can be setup as a router/access point, WiFi extender or WiFi repeater. Multiple languages of this document and additional product information are available on https://genexis.eu/download-portal/#pulse Box contents • Genexis Pulse EX400 Pulse EX400 • Power adapter • RJ45 Network cable • Label (self-adhesive) •...
- Page 5 Setting up the Pulse 4. Wait until the Status, 2.4G and 5G WiFi Repeater 3. On your router, initiate WPS pairing. The Pulse EX400 can be setup in indicator LEDs are fixed green. 1. Plug the DC adapter into an 4.
- Page 6 EU Declaration of Conformity Is the Status indicator LED red? Reset the device Hereby, Genexis B. V . declares that the product Pulse EX400 is in compliance with Contact your service provider. The reset button resets the device to Directives 2014/53/EU, 2009/125/EC, 2011/65/EU and Delegated directive factory settings.
- Page 7 Revision 1.0 September 2019, Copyright © 2019 Genexis B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the Pulse Series and is the answer not in the manual?
Questions and answers