Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Genexis Pulse Series
Summary of Contents for Genexis Pulse Series
- Page 1 EX600 Pulse Series Installation Guide Wi-Fi EasyMesh supported...
- Page 2 * This installation guide is applicable to setup the Pulse EX600 as a wireless or wired extender back of the Pulse EX600 to mount in combination with a Genexis router which supports the WiFi EasyMesh™ standard. For other combinations please refer to the Genexis website at https://genexis.eu/product/pulse/installation-guide the device to the screws.
- Page 3 LED will start blinking blue. the power port at the back of the 6. On the Genexis router, initiate the Pulse EX600. automated pairing (WPS) within 3. Flip the ON/OFF switch at the two minutes according to the back of the device to turn it on.
- Page 4 You can connect your personal EX600 LAN port (yellow connector). device to the Pulse EX600 via manual Follow the instructions of the Genexis • Wireless connection: Connect your pairing. If automated pairing (WPS) router in case the Pulse EX600 is in...
- Page 5 LED & button overview Status Green – system is operational ready Green (blinking) – connectivity lost Yellow – system startup or WiFi OFF Yellow (blinking) – system is not ready Blue – automated pairing (WPS) successful Blue (blinking) – automated pairing (WPS) in progress –...
-
Page 6: Port Overview
Port overview WAN port Power port Reset ON/OFF USB 2.0 LAN ports button switch port Reset button (recessed) ON/OFF switch Reboot – press and release once Switch ON – flip the switch to ON Factory reset – press and hold until the Switch OFF –... -
Page 7: Troubleshooting
2. Wait until the Status LED turns Automated pairing (WPS) between router and the Pulse EX600 is solid green again. the Pulse EX600 and Genexis router not stable. Please check the cable or personal device failed. Please follow connection with the Genexis router... -
Page 8: Eu Declaration Of Conformity
EU Declaration of Conformity Hereby, Genexis Netherlands B. V . declares that the product Pulse EX600 is in compliance with Directives 2014/53/EU, 2009/125/EC, 2011/65/EU and Delegated directive 2015/863. The full text of the EU declaration of conformity is available at the following internet address: https://genexis.eu/product/pulse/red/pulse-ex600... - Page 9 Revision 1.4 February 2022, Copyright © 2022 Genexis Netherlands B. V . All rights reserved. Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the right to change, modify, transfer, or otherwise revise this publication without notice.
Need help?
Do you have a question about the Pulse Series and is the answer not in the manual?
Questions and answers