Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Genexis FiberTwist PX2110
Summary of Contents for Genexis FiberTwist PX2110
- Page 1 FiberTwist PX2110 Installation Guide...
-
Page 2: Button Overview
Button overview Port overview Power port ON/OFF LAN port button Unlock button Remove FiberTwist or Blind Cover – press and hold while twisting counterclockwise Reset button (recessed) Reset - press and release Factory reset - press and hold the button until System and Uplink LED start to blink LED dim button Dim LEDs –... -
Page 3: Led Overview
LED overview System Green – system ok Green (blinking) – booting Red – system or booting failure Red (blinking) - insufficient PON signal Off – power off Uplink Green – link ok Green (blinking) – link establishing Off – no link System + Uplink Green (blinking) –... - Page 4 1. Press and hold the unlock button (see button overview). Box contents 2. Rotate the Blind Cover counterclockwise till it blocks. • Genexis FiberTwist (active Important: Instructions need 3. Remove the Blind Cover from the baseplate (FTU) by pulling device) to be followed precisely it towards yourself.
- Page 5 Remove dust cap Twist! 1. Take the FiberTwist out of the box. 1. Place the FiberTwist on the FTU as shown in the picture below, 2. The dust cap is connected to the red string in a 30–degree angle. located on the rear of the FiberTwist. 2.
-
Page 6: Eu Declaration Of Conformity
Connecting the FiberTwist 1. Connect your gateway to the LAN (10GE) port via an RJ45 network Hereby, Genexis Netherlands B.V. declares that the product FiberTwist- cable. A CAT6 cable or better is recommended. PX2110 is in compliance with Directives 2014/30/EU, 2014/35/EU, 2. - Page 7 Revision 1.0 - April 2025 - Copyright © 2024 Genexis Netherlands B.V. All rights reserved. Multiple languages of this document and additional product information are available on https://genexis.eu/product/fibertwist-PX2110/ Genexis assumes no responsibility for any inaccuracies in this document. Genexis reserves the...
Need help?
Do you have a question about the FiberTwist PX2110 and is the answer not in the manual?
Questions and answers