Install The Log Assembly - Majestic QUARTZ Series Installation Manual

D. Install the Log Assembly
Log Set Assembly: LOGS-QUARTZ32, LOGS-QUARTZ36
Models: QUARTZ32IN, QUARTZ32IL, QUARTZ36IN, QUARTZ36IL
QUARTZ32IFTN, QUARTZ32IFTL, QUARTZ36IFTN, QUARTZ36IFTL
Install Logs
CAUTION: Logs are fragile, handle with care.
Overview
These are common log instructions for the QUARTZ32
and QUARTZ36 models. Each model uses 8 logs, 6 logs
are common logs between the two sizes. Log position is
controlled by two log pins (installed on burner) and four
hand bend tabs located in the base pan.
*The photos shown in these instructions depict a QUARTZ36
model.
Log Identification:
Reference Figure 2 for log identification of logs. It is
important to lay the logs out in order as shown in Figure
2. Some logs are similar to others in shape or size so it
is imperative to correctly identify each log. The rear right
log (#2) and the front right log (#4) that rest on the burner
are different between the two sizes.
QUARTZ32 MODELS
EMBERS NOT ALLOWED
EMBERS
QUARTZ36 MODELS
EMBERS
Figure 1. Log Pin and Glowing Ember Locations
Majestic • QUARTZ32IFTN/L, QUARTZ36IFTN/L, QUARTZ42IFTN/L Installation Manual • 2641-980 Rev. C • 9/20
IN SHADED AREA
LOG PINS
EMBERS NOT ALLOWED
IN SHADED AREA
LEFT REAR BASE LOG LEFT REAR BASE LOG
1
LEFT FRONT BASE LOG RIGHT FRONT BASE LOG LEFT FRONT BASE LOG
3
TOP LEFT LOG TOP LEFT LOG
5 6
MIDDLE LEFT MIDDLE LEFT
CROSS LOG CROSS LOG
Figure 2. Log Assembly Components - QUARTZ36 Shown
1. Locate the four hand bend tab on the base pan and
bend each tab up to 90 degrees. See Figure 3.
HAND BEND TABS HAND BEND TABS
Figure 3. Hand Bend Tab Locations - QUARTZ36 Shown
LOG PLACEMENT
INSTRUCTIONS
RIGHT REAR BASE LOG RIGHT REAR BASE LOG
2
RIGHT FRONT BASE LOG
4
TOP RIGHT LOG TOP RIGHT LOG
7
MIDDLE RIGHT MIDDLE RIGHT
CROSS LOG CROSS LOG
8
61