Prepare For Heat Management; Securing And Leveling The Appliance - Majestic QUARTZ Series Installation Manual

B. Prepare For Heat Management
NOTICE: Additional clearances are required for heat
management systems installations. Provisions must be
made in advance to ensure fit within the framing.
• Heat management systems include Heat-Zone
and Heat-Out-Gas Contact your dealer for information.
• Locate the heat management ports on the left and right
sides of the appliance. One or two Heat-Zones
Heat-Out-Gas kit may be installed. See Figure 6.17.
Remove the knockouts from the appliance with a tin
snips.
• Center the duct collar around the exposed hole and
attach it to the appliance with 3 screws. Note: Do this
BEFORE final positioning of the appliance.
• Determine the location for the air register/fan housing
assembly.
Reference the instructions
management kit for the remaining installation steps.
HEAT MANAGEMENT PORTS
LEFT AND RIGHT SIDES
Figure 6.17 Heat Management Port Locations
Majestic • QUARTZ32IFTN/L, QUARTZ36IFTN/L, QUARTZ42IFTN/L Installation Manual • 2641-980 Rev. C • 9/20
40
- Gas
®
or one
®
included in the heat
C. Securing and Leveling the Appliance
WARNING
Risk of Fire!
Prevent contact with:
• Sagging or loose insulation
• Insulation backing or plastic
• Framing and other combustible
materials
DO NOT remove standoffs or notch the framing
around the appliance standoffs.
Failure to maintain air space clearance could
cause overheating and fire.
Block openings into the chase to prevent entry
of blown-in insulation. Make sure insulation and
other materials are secured.
The diagram shows how to properly position and secure
the appliance. See Figure 6.18. Nailing tabs are provided
to secure the appliance to the framing members.
• Bend out nailing tabs on each side.
• Place the appliance into position.
• Keep nailing tabs flush with the framing.
• Level the appliance from side to side and front to back.
• Shim the appliance as necessary. It is acceptable to use
wood shims underneath the appliance.
• Place a level on top, sides and bottom as shown in Figure
6.18.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs. Use a minimum of one
fastener per nailing tab.
• Optional: Secure the appliance to the floor by inserting
two screws through the pilot holes at the bottom of the
appliance.
NAILING TABS
(BOTH SIDES)
PLACE LEVEL ON THESE SURFACES
Figure 6.18 Proper Positioning and Securing of an Appliance