Malfunctions; Error Messages; Description Of The Error Messages - Pfaff EcoDrive P40 ED Instruction Manual

Sewing
8

Malfunctions

.03
8

Error messages

.03.01
When an error occurs, an error code appears on the display together with short instructions.
An error message is caused by incorrect settings, defective elements or seam programs as
well as by overload conditions. See Chapter 8.03.02 Description of the error messages for a
description of the error codes.
●
●
8

Description of the error messages

.03.02
30
E009
PRESS TE-SPEED
Eliminate error.
Acknowledge error elimination by pressing the "TE/speed" key.
Error
Cause
code
E001 Pedal not in rest position when
machine is switched on
E009 Start inhibitor at standstill
E010 Machine class altered
E062 Voltage of power supply unit (24 V)
too low
E063 Power supply unit (24 V) overloaded
E064 "Mains off" signal when machine is
switched on
E065 IGBT error when machine is swit-
ched on
E066 IGBT test with error recognition
E067 Mains off
E068 Overcurrent motor during operation
Remedy
Check pedal
Bring sewing head to its basic positi-
on
Switch control unit off, then on again.
Check connected consumers
Check connected consumers
Contact service
Contact service
Contact service
Switch on mains
Contact service