Pfaff EcoDrive P40 ED Instruction Manual page 15

Raised needle position after sewing stop
●
If this key is pressed, the "raised needle position after sewing stop" function is switched
on or off. If the function is switched on, the needle positions in t.d.c. after sewing stops
Raised foot position after sewing stop
●
If this key is pressed, the "raised foot position after sewing stop" function is switched on
or off. If the function is switched on, the sewing foot is raised after sewing stops.
Raised foot position at end of seam sector (in programmed sewing)
●
If this key is pressed, the "raised foot position at end of seam sector" function is switched
on or off. If the function is switched on, the sewing foot is raised at the end of the seam
sector.
Thread trimming
●
If this key is pressed, the "thread trimming" function is switched on or off.
Program speed (only in programmed sewing)
●
If this key is pressed, the relevant function is switched on or off.
If the function is activated, the pedal forwards function is used to select the program
speed as a fi xed speed. The pedal setting for stopping the fi xed speed is chosen with
parameter 206.
●
If the function is switched off, the speed is regulated with the pedal until program speed
is reached.
Reverse sewing direction (only in programmed sewing)
●
If this key is pressed, the relevant function is switched on or off. If the function is activa-
ted during programmed sewing, the relevant seam sector is sewn in reverse.
Manual sewing sector (only in programmed sewing)
●
If this key is pressed, the relevant function is switched on or off.
If the function is activated, switching to the next seam sector is not carried out by stitch
counting or sensor, but manually with the pedal setting "-2".
Programmed sewing stop (only in programmed sewing)
●
If this key is pressed, the relevant function is switched on or off.
If the function is activated, the machine stops at the end of the seam sector.
Sewing with light barrier
●
In the manual sewing mode with light barrier, the number of stitches entered with para-
meter 111 corresponds to the light barrier compensation stitches. In the programmed se-
wing mode, the number of stitches in the seam sector is used as the number of compen-
sation stitches.
Stitch counting (only in programmed sewing)
●
If this key is pressed, the relevant function is switched on or off.
●
If the function is activated, in the programmed sewing mode the machine switches to
the next seam sector after the number of stitches entered have been sewn.
Control elements
15