Midea MAW25R1YWT User Manual page 6

NOTE
The power supply cord with this air
conditioner contains a current detection
device designed to reduce the risk of fire.
Please refer to the section Operation of
Current Device for details.
In the event that the power supply cord
is damaged, it can not be repaired. It
must be replaced with a cord from the
manufacturer.
MAW15 (15,000 BTU) Plug
Grounding type wall receptacle
Do not, under any
circumstances, cut,
remove or bypass
the grounding prong.
Power supply cord with 3-prong grounding
plug and current detection device.
MAW18 / MAW25 (18,000 BTU / 25,000 BTU) Plug
Grounding type wall receptacle
Do not, under any
circumstances, cut,
remove or bypass
the grounding prong.
Power supply cord with 3-prong grounding
plug and current detection device.
 Page 6 
WARNING - For your safety
• Do not store or use gasoline
or other flammable vapors and
liquids in the vicinity of this or any
other appliance.
• Avoid fire hazard or electric shock.
Do not use an extension cord or an
adaptor plug. Do not remove any
prongs from the power cord.
WARNING - Electrical Information
The complete electrical rating of
your new room air conditioner is
stated on the rating label. Refer
to the rating when checking the
electrical requirements.
• Be sure the air conditioner is
properly grounded. To minimize
shock and fire hazards, proper
grounding is important. The
power cord is equipped with a
three-prong grounding plug for
protection against shock hazards.
• Your air conditioner must be
used in a properly grounded
wall receptacle. If the wall
receptacle you intend to use is not
adequately grounded or protected
by a time delay fuse or circuit
breaker, have a qualified electrician
install the proper receptacle.
• Ensure the receptacle is accessible
after the unit installation.
• Do not run air conditioner without
outside protective cover in place.
This could result in mechanical
damage within the air conditioner.