Midea MAW25R1YWT User Manual page 19

Locking Screw
Window Sash
Seal
Fig. 30
Safety Lock
8 Install Chassis into Cabinet and Install Front to Unit
1. Lift air conditioner and carefully slide into cabinet leaving 6" (152mm) protruding.
2. DO NOT press or apply pressure to controls or finned coils.
3. Be sure chassis is firmly seated towards rear of cabinet.
4. Installation of front is the reverse of removal outlined in Section 1.
Removing AC From Window
• Turn AC off, and disconnect power cord.
• Remove sash seal from between windows, and unscrew safety lock.
• Remove screws installed through frame and frame lock.
• Close (slide) side panels into frame.
• Keeping a firm grip on air conditioner, raise sash and carefully remove.
• Be careful not to spill any standing water while lifting unit from window. Store parts
WITH air conditioner.
6 Extend Window Accordion Panels
7/16"
Locking
Screw and
Washer
Fig. 29
7 Install Window Sash Seal and Safety Lock
1. Trim sash seal to fit window width. Insert into
space between upper and lower sashes (Fig. 30).
2. Attach right angle safety lock (Fig.
3/4" (or 1/2") Long
Hex-head Screws
Fig. 31
1. Carefully raise window to expose
accordion panel locking screws.
Loosen screws so accordion panels
slide easily.
2. Extend panels to fill window
opening completely. Tighten
locking screws on top (Fig. 29).
3. Close window behind top rail.
31).
 Page 19 