Midea MAW25R1YWT User Manual page 18

Bottom
Rail Seal
Fig. 25
Mark
Fig. 26
Left
Locknut
Sill Angle
Bracket
Flathead Bolt
Fig. 27
Fig. 28
 Page 18 
3/4" (or 1/2") Long
Hex-head Screw
5 Install Support Bracket
1. Hold each support bracket flush against outside of
sill, and tight to bottom of cabinet as shown in Fig.
26. Mark brackets at top level of sill, and remove.
1/2" Long Screws
and Locknuts
Right
2 Each Required For
Each Support Bracket
1/2" Long
Screws and
Locknuts
3. Shift cabinet left or right as needed
to line up center of cabinet on center
line marked on sill.
4. Fasten cabinet to window sill with 2
screws into holes (You may wish to
pre-drill pilot holes).
5. Add bottom rail seal over screws to
window sill. (Fig. 25).
2. Assemble sill angle bracket to support
brackets at the marked position (Fig.
27). Hand tighten only so adjustments
can be made later.
3. Install support brackets (with sill angle
brackets attached) to correct hole in
bottom of cabinet as shown in Fig. 28.
4. Tighten all 6 bolts securely.