Barco Nio Fusion12MP User Manual page 14

Installation and setup
Barco suggests to have QAWeb installed on only one of both workstations. When both workstation
would have QAWeb installed, switching KVM inputs would trigger a Configuration Change event,
causing the display to disappear from the workstation in QAWeb.
Install the display controllers
Before you connect your display with the workstations, make sure to have a suitable
installed in both workstations.
The Nio Fusion 12MP display operates at its full specifications when driven by a Barco MXRT
display controller and MXRT driver (which also includes the Barco Intuitive Workflow Tools). If
you ordered a MXRT display controller, it is included in the box of your display.
For more information and installation instructions, please check the Barco "Display Controller and
Intuitive Workflow Tools" user guide on the included documentation CD, or at
www.barco.com/support.
Connect the cables
1. Remove the connector cover.
2. Connect DisplayPort input 1 (DP IN 1) with the DisplayPort output on workstation 1.
3. Connect the main USB upstream connector (USB UP 1) with a USB host on workstation 1.
4. Connect DisplayPort input 2 (DP IN 2) with the DisplayPort output on workstation 2.
5. Connect the secondary USB upstream connector (USB UP 2) with a USB host on workstation 2.
Note: The USB UP 2 connector is covered by a plastic cap which has to be removed first.
6. Connect a keyboard and mouse (or another peripheral used to control the workstations) with the USB
downstream connectors of the display. One USB downstream connector is available in the connector
compartment, a second one at the side of the display.
7. Connect the supplied mains cable to the power input on the display.
8. Route all cables through the cable clips in the connector compartment.
9. Re-install the connector cover: slide the top of the cover in the available recesses, then push the bottom of
the cover back into position.
10. Route some or all cables through the routing channels in the stand of your display.
11. Connect the supplied mains cable to a grounded power outlet.
2. For a list of compatible display controllers, please refer to the compatibility matrix available on my.barco.com (MyBarco > My Support
> Healthcare > Compatibility Matrices > Barco Systems Compatibility Matrices)
14 R5913350 /02 Nio Fusion 12MP
2 display controller