Table of Contents
Advertisement
Installation and setup
3.
Enter the KVM Input Selection submenu.
4.
Select Enabled and confirm.
When enabling the KVM switch, the Image Source Selection menu will be inaccessible. In addition,
Hibernate will be disabled to guarantee correct USB port switching also when one or both
workstations are in sleep mode.
To switch KVM inputs
1.
Press or turn the jog dial to activate the shortcut bar. The KVM switch icon (
default because the KVM switch is enabled.
2.
Press the jog dial again to switch KVM inputs.
During normal operation, double-press the jogdial to switch KVM inputs more quickly. A first click
will make the shortcut bar pop up, a second click will switch inputs (since the KVM switch icon is
selected by default when the KVM switch is enabled).
When switching KVM inputs, the video is switched instantly while switching the USB signal might
take a little longer (up to 2 seconds).
The DisplayPort standard must be DP V1.2 for both DisplayPort inputs. This is the factory default.
See "DisplayPort standard version", page 37 to change the DisplayPort standard.
2.3 QAWeb registration
About
QAWeb Enterprise helps you manage quality and assure compliance of your expanding healthcare
enterprise with less effort, lower cost, and complete confidence. This fully automated and secure system
guarantees a consistent image quality and uptime for all registered imaging display systems within your facility
and across your enterprise. Learn more at www.barco.com/qaweb.
To register your display system to your QAWeb Enterprise organization, the QAWeb Enterprise Agent must be
installed and running on your workstation and it must be able to communicate with the QAWeb Enterprise
cloud service.
For
more
information
www.barco.com/support/qaweb-enterprise.
When still using the older MediCal QAWeb, visit
the installation package and user documentation.
2.4 VESA-mount installation
CAUTION: Use suitable mounting apparatus to avoid risk of injury.
WARNING: Never move a display attached to an arm by pulling or pushing the display itself.
Instead, make sure that the arm is equipped with a VESA compliant handle and use this to move
the display.
Please refer to the instruction manual of the arm for more information and instructions.
WARNING: Use a mount that is compliant with the VESA 100 mm standard.
Use a mount that can support the weight of the display. Refer to the technical specifications of this
display for the applicable weight.
16
R5913350 /02
Nio Fusion 12MP
and
instructions,
check
the
QAWeb
Enterprise
www.barco.com/support/medical-qaweb
) is now selected by
user
guide
on
to obtain
Advertisement
Table of Contents
