Wiper And Cleaner Of Windshield - BYD L3 QCJ7153 A Owner's Manual

Wiper and Cleaner of Windshield

The switch is used to control the front
windshield wiper and washer and is
divided into five shifts.
MIST: Spot wiping mode
OFF: Turned off
INT: Interval shift
LO: Low speed shift
HI: High speed shift
To select a shift, please push upward or
press downward the control lever.
L3 Owner's Manual
In low speed shift and high speed shift,
the wiper continuously works.
To have the wiper work in spot wiping
mode, please push the control lever
upward from OFF position and the wiper
will scrape in high speed until the control
lever is released. In this way, the
windshield can be cleaned soon.
At interval shift, the wiper works for a
cycle every 3 to 4 seconds. The shift
position is suitable for small rain.
To spray cleanser, please move the right
combined switch upward and then
release it. After spraying cleanser, the
wiper will work for twice.
For details of adding cleanser, please
refer to Chapter 7-3 "Adding cleanser".
To use cleanser in freezing weather,
please warm up and
windshield glass before applying it. This
will prevent the cleanser from being
frozen on windshield to obstruct vision.
【Add cleanser】
If the cleaner does not work, the reason
might be that the cleanser has run out.
Please check liquid level scale for
cleanser level. If the cleanser level is
"LOW", please add cleanser.
NOTICE
Do not use pure water as cleanser in
cold area or in cold
Otherwise, the cleaner inside, cleaner
nozzle or cleaning tube inside might
freeze and the cleaner motor might
be damaged.
Lighting, Wipers, Defrosters 1-71
defrost the
season.