Notes On Aluminum Tire - BYD L3 QCJ7153 A Owner's Manual

Table of Contents

Advertisement

If you do not replace a damaged tire, the
tire might come off the wheel and the car
might get out of control.
Wheel selection
When replacing wheel, please use a
new wheel with same load capacity,
diameter, wheel width and offset as
the older one.
BYD authorized service station can
replace wheel correctly.
A wheel with different size or type might
inflict unfavorable effect on operation,
service life of wheel and bearing, cooling
of brake, speedometer/odometer setting,
braking
performance,
accuracy, bumper height, distance from
the ground, distance between tire or tire
chain and car body or chassis.
Do not replace with an old tire. The old
tire might have been disposed or have
run for a long way and fault might occur
without any sign. Likewise, the aligned
bent wheel has damaged structure.
Therefore, do not use it. Do not use an
inner tube designed for a tubeless tire in
L3 Owner's Manual
a leaking wheel.
FRIENDLY TIPS
As it might cause a typical operation
risk and the car out of control, please
do not use a tire other than that with
size recommended by the manuf
-acturer. Otherwise, it might cause
death or severe injury.

Notes on Aluminum Tire

● For a car equipped with aluminum
wheel, please check to make sure
the wheel nut is tightened within the
initial 1600 km.
● If a tire is exchanged, repaired or
headlight
replaced, please check to make sure
the wheel nut is tightened after
driving for 1600 km.
● While using tire chain, take care not
to damage the aluminum wheel.
● Please use BYD wheel bolt and
spanner designed for aluminum
wheel only.
● When adjusting wheel balance with
tire chain, please use BYD balance
block and plastic hammer or rubber
hammer only.
● Just as with any other the vehicles,
please check to make sure the
aluminum wheel is not damaged. In
the case of damage, please replace
immediately.
Engine and Chassis 7-15

Advertisement

Table of Contents
loading

Table of Contents