Check The Engine Oil Level - BYD L3 QCJ7153 A Owner's Manual

Check the Engine Oil Level

While the engine is
temperature, please turn off the engine
and check oil level with oil dip rod.
1. In order to obtain a correct reading,
please park your car on flat ground.
Please wait for a few minutes after
turning off the engine until the engine oil
collects at the bottom of the engine.
2. Pull out oil Dipstick and place a piece
of cloth at its end and clean it.
3. Insert Oil Dipstick again. Please insert
it to the end. Otherwise, the indication is
not accurate.
4. Pull out oil Dipstick and place a piece
of cloth at its end and check oil level.
Do not dip the engine oil onto the
vehicle parts.
If oil level is lower or slightly higher
than low oil level, please fill the
engine oil of the same type into the
engine.
Remove the engine oil cap, fill small
quantity of the engine oil every time and
in working
check oil dip rod. It is recommended that
you use funnel to fill the engine oil.
The appropriate quantity of required the
engine oil is between low level and high
level for reference.
When oil level reaches normal scope,
please install filling cap and fasten it
manually.
L3 Owner's Manual
NOTES
NOTES
●
Do not dip the engine oil onto the
vehicle parts.
●
Do not add too much fuel.
Otherwise, the engine might be
damaged.
●
After adding fuel, please check
oil level on oil Dipstick again.
Selection of the engine oil
Please use lubricant approved by BYD
authorized service station
equivalent in compliance
following class and viscosity.
Class of gasoline the engine oil:
above -30 ℃
SAE 5W—30
SAE 15W—40 above -15 ℃
API class, SG level or above.
Quantity: 3L
Recommended the
viscosity (SAE):
or the
with the
engine oil