Add Cleanser; Replace Bulb - BYD L3 QCJ7153 A Owner's Manual

FRIENDLY TIPS
Never use fuse whose amperage is
higher than rated value or anything
else. Otherwise, it might
severe damage and cause fire.

Add Cleanser

If a cleaner does not work, it could be
because that the cleaner overflow
kettle might have become empty.
Please check cleaning mixture level
on level gauge. If cleanser level is
"LOW",
lower than
cleanser.
cause
Before adding cleanser
Pull out the cleanser funnel and hang
it on support holder of the engine
hood.
Clean water may serve as cleanser.
However,
temperature is below 0 degree of
centigrade,
containing
product is available in BYD authorized
service station and most automobile
please add
parts shop. Refer to the manufacturer
instruction for mixture ratio of water.
L3 Owner's Manual
in a cold area, when
please use cleanser
anti-freezing agent. The
After adding cleanser into overflow
kettle, please put funnel back to its
original position.
NOTES
Do not use the engine anti-freezing
agent or other substitute. Otherwise,
it might damage paint layer of the car.

Replace Bulb

The following diagram shows how to
remove a bulb. When replacing a bulb,
please confirm that ignition switch and
lamp switch are in OFF status. Use a
bulb with the same rated power as that
in the following table.
NOTES
Only the bulbs specified in the
following table can be used.
Top-mount stop light, tail stop light and
rear lamp are using LED. If the number
of burned LED goes against related
local regulation, please contact BYD
authorized service station for bulb
replacement.
Electrical Appliance Parts 7-21