Table of Contents
Advertisement
Before Starting the Engine
1.
Before coming inside the car,
please check surrounding of the
car.
2.
Please adjust seat position, seat
height, seat back angle, head
protection
device
steering wheel angle.
3.
Adjust
internal
and
rearview mirror.
4.
Lock all car doors.
5.
Fasten seat belt.
Once you set anti-theft system by
pressing LOCK on wireless remote
control, you must press UNLOCK before
starting the engine. Otherwise, you
cannot start the engine.
Engine Starting Methods
(a) Before starting
Manual transmission:
Starting and Driving 3-2
1.
Check parking control mechanism.
2.
Turn off all unnecessary car light
and accessories.
3.
Set the gear shifting lever at neutral
position.
height
and
4.
Press the clutch pedal to the end
and hold until the car moves.
external
5.
Release anti-theft system.
(b) The engine starting
Before starting the engine, please
confirm the steps in "(a) before starting"
have been performed.
Normal starting procedures
The multi-point fuel injection system in
the engine controls proper mixture of air
and fuel used for starting. Perform the
following procedure to start the engine in
cold or warm condition.
Start the engine in accordance with
instruction in the section of the smart
key system access function and starting
L3 Owner's Manual
function.
The engine may be warmed through
driving instead of through idle driving.
Operate the engine in a steady way to
warm up the car until the engine coolant
temperature rises to a normal scope.
If the engine stalls
Start the engine again in correct
procedure.
If the engine cannot start
Refer to Chapter 4 "if the car fails to
start".
NOTICE
●
Starting operation of the engine
shall not exceed 30 seconds
each time. Otherwise, it might
cause overheating of the starter
or the circuit system.
●
Avoid running the engine at
overspeed.
●
If it is difficult to start the engine
or the engine often stalls, please
examine the engine immediately.
Advertisement
Chapters
Table of Contents
