Table of Contents
Advertisement
Handling and Safety Instructions
1 Handling and Safety Instructions
Strassheimer Str. 45; 61169 Friedberg - Germany; Tel. +49 6031-6842611; Fax +49 6031-6842612
Depending on the operating conditions, the housing temperature can exceed 60 °C.
There is a risk of injury!
Handle with care! The housing, especially heat sinks can have sharp edges. There is
a risk of injury!
EMC conformity according to EN/IEC 61000-6-2:2005 is qualified for cable lengths ≤
30 m.
Electrostatic discharge at unshielded I/O connectors can lead to unexpected events
or data errors for the corresponding interface.
Electrical installation should be executed without power applied to the device and
connected devices.
Before installing expansion cards, make sure that the VisionBox AGE-X is discon-
nected from power.
Use appropriate ESD protection when changing components.
Only open if advised by IMAGO!
Warranty void if warranty seal is removed or broken.
Please take special note of the voltage range which may be applied to the device.
Otherwise, permanent damage to the device may result!
Air Circulation
When mounting the device within an enclosure, adequate space for air circulation
is required. The
space above, below and at both sides should be at least 5 cm.
Avoid extreme environmental conditions and protect the VisionBox from dust,
humidity and heat.
Due to the characteristics and physical principles inside flash memory, SSDs have a
finite lifetime dictated by the number of write operations.
Therefore, take care of the regular write operations to prevent an early SSD dam-
age. Ask for the technical data of the used SSD and, if necessary, for support to
calculate the lifetime.
Inform the user of the system that SSDs are wear parts which must be renewed
regularly.
IMAGO Technologies GmbH
info@imago-technologies.com; www.imago-technologies.com
Page 4 / 36
Advertisement
Table of Contents
