Camera Trigger - IMAGO VisionBox AGE-X5 Hardware Manual

5 Interfaces

5.8.2 Camera Trigger

The electrical behavior of the camera trigger output can be controlled via software. Each output
has two transistors, one for the positive and one for the negative side. Both transistors can be
programmed independently. Therefore, the output can be configured in push-pull, open-collector
or emitter-follower configuration:
The high-side switch is connected to the power supply voltage of the VisionBox and has a current-
limiting circuit.
Strassheimer Str. 45; 61169 Friedberg - Germany; Tel. +49 6031-6842611; Fax +49 6031-6842612
+24V
Power
Current
Supply
GND
limit
Real Time
Communication
Controller
VisionBox
Figure 23: Simplified camera trigger diagram
IMAGO Technologies GmbH
info@imago-technologies.com; www.imago-technologies.com
Current
limit
ACQ TRG
(FPGA)
ACQ GND
Page 31 / 36