Table of Contents
Advertisement
Siemens Building Technologies
Fire Safety & Security Products
Alarm parameters
1.
You must first parameterise your alarm configuration in the
dialogue screen (see section 10). The settings
Parameters
and
No. of Active alarm lines
2.
Once you have set the basic alarm parameters, you must set the way the
alarm contact functions (normally open / normally closed) for each detection
group in the
Alarm lines/camera groups
You can set the appropriate camera group here if more than one camera is to
be switched when an alarm is triggered.
3.
Now use the
Alarm switching configuration
to determine which monitors switch alarm images and how switching takes
place.
4.
In the
Alarm reset mode and stack alarm note
(see section 13), you can set the reset mode of the alarm monitors.
These are the most important dialogue screens. Please refer to the relevant
chapters for more detailed information.
are particularly important
dialogue screen (see section 11).
dialogue screen (see section 12)
dialogue screen
General
Basic Alarm
1 st Alarm line at
15
06.2008
Advertisement
Table of Contents
